Between the Delrin and POM-C rods, both materials are quite tough and easily machinable, and they have similar physical properties. They look similar, but for practical uses there are some differences that may make one better than the other. It also depends on your application. As with all plastic materials, be sure to check the typical properties data sheet for the applicable properties you may need for your application. Dupont Delrin is the best plastic for turning on a lathe lathe. It is easy to turn, but it requires slower speeds. I use this stuff to make Scottish small pipes chanters. I have purchased countless items from iPlastic. Smaller parts usually ship promptly and everything was well packed. I’ve never had an issue with an order. Between the Delrin and POM-C rods, both materials are exceptionally tough and easily machinable, as they have Acetal versus Delrin similar physical properties. They do look the same, but for practical uses there are a few differences that may make one preferable than the other. It also depends on your application. As with any plastic materials, make sure to check the typical properties data sheet for the applicable properties you may need for your application.
0 Comments
Leave a Reply. |